Initio scsi card driver Cleaning will effectively remove dust, oil and paper debris from the rollers and scanning head. Click on the Advanced tab to access the Clean and Calibrate buttons; follow the onscreen directions as above. 1 - Initio Technical Support 2 - Diskette Contents 3 - Description 4 - MS-DOS 5 - Windows 95/98 6 - INI-9200U/UW, INI-9400U/UW 7 - INICD.SYS 8 - INIDISK.SYS 9 - INIFDISK.EXE 1 - Initio Technical Support-By mail: Initio Corporation 2188B Del Franco St. San Jose, CA 95131 Phone: 408-965-5039 FAX: 408-577-0640 Internet: email protected http.
It is important to pick a SCSI controller carefully. Many cheap ISA SCSI controllers are designed to drive CD-ROM's rather than anything else. Such low-end SCSI controllers are no better than IDE. See the SCSI HOWTO and look at performance figures before buying a SCSI card.
Please see the SCSI RAID controller section for information on SCSI controllers with hardware RAID support.
8.1. SupportedInitio SCSI & RAID Devices Driver Download
AMI Fast Disk (VLB/EISA) (BusLogic compatible)
Adaptec AVA-1502E (ISA/VLB) (AIC-6360) (AHA1520)
Adaptec AVA-1505/1515 (ISA) (Adaptec AHA-152x compatible)
Adaptec AVA-1825 (VLB) (Adaptec AHA-152x compatible)
This card has a SCSI, EIDE and floppy port which all work nicely.
Adaptec AHA-1510/152x (ISA/VLB) (AIC-6260/6360)
Adaptec AHA-154x (ISA) (all models)
Adaptec AHA-174x (EISA) (in enhanced mode)
Adaptec AHA-274x/274xT (EISA) (AIC-7771). The 274xT is supported since kernel series 2.1.x (AHA2740)
Adaptec AHA-284x (VLB) (AIC-7770) (AHA2740)
Adaptec AHA-2910B (PCI) (since kernel series 2.1.x)
Adaptec AHA-2920 (PCI). Use the Future Domain driver. LILO parameters are needed when used for hard disks.
Adaptec AHA-2920C (PCI)
Adaptec AHA-2930/U/U2 (PCI)
Adaptec AHA-2940/U/W/AU/UW/U2W/U2/U2B/U2BOEM (PCI) (AIC-7861, AIC-7871, AIC-7844, AIC-7881, AIC-7884). Some of these are only supported since kernel series 2.1.x (AHA2740)
Adaptec AHA-2944D/WD/UD/UWD (PCI). Some of these are only supported since kernel series 2.1.x (AHA2740)
Adaptec AHA-2950U2/U2B/U2W
Adaptec AHA-3940/U/W/UW/AUW/U2W (PCI) (AIC-7872, AIC-7882) (since 1.3.6). Some of these are only supported since kernel series 2.1.x
Adaptec AHA-3950U2B/U2D
Adaptec AHA-3985U/W/UW (PCI) (AIC-7873, AIC-7883). Some of these are only supported since kernel series 2.1.x
Adaptec PCI controllers with AIC-7850, AIC-7855, AIC-7860
Adaptec on board controllers with AIC-777x (EISA), AIC-785x, AIC-786x, AIC-787x (PCI), AIC-788x (PCI), AIC-789x, AIC-3860. AIC-786x and AIC-789x are supported since kernel series 2.1.x
AdvanSys ABP510/5150 Bus-Master (ISA)
(more info)
AdvanSys ABP5140 Bus-Master (ISA) PnP
(more info)
AdvanSys ABP5142 Bus-Master (ISA) PnP with floppy
(more info)
AdvanSys ABP920 Bus-Master (PCI)
(more info)
AdvanSys ABP930/U Bus-Master (PCI/Ultra>)
(more info)
AdvanSys ABP960/U Bus-Master (PCI/ULTRA) MAC/PC
(more info)
AdvanSys ABP542 Bus-Master (ISA) with floppy (single channel)
(more info)
AdvanSys ABP742 Bus-Master (EISA) (single channel)
(more info)
AdvanSys ABP842 Bus-Master (VL) (single channel)
(more info)
AdvanSys ABP940/U Bus-Master (PCI/Ultra) (single channel)
(more info)
AdvanSys ABP970/U Bus-Master (PCI/Ultra) MAC/PC (single channel)
(more info)
AdvanSys ABP752 Dual Channel Bus-Master (EISA) (dual channel)
(more info)
AdvanSys ABP852 Dual Channel Bus-Master (VL) (dual channel)
(more info)
AdvanSys ABP950 Dual Channel Bus-Master (PCI) (dual channel)
(more info)
Always IN2000
AMD AM53C974
BusLogic FlashPoint LT/DL/LW/DW (BT-930(R), BT-920, BT-932(R), BT-950(R), BT-952(R))
(more info)
Compaq Smart Array 2
DPT PM2001, PM2012A (EATA-PIO)
DPT Smartcache/SmartRAID Plus,III,IV families (ISA/EISA/PCI) (EATA-DMA)
Take a look at this page for more information. Cards in these families are PM2011, PM2021, PM2041, PM3021, PM2012B, PM2022, PM2122, PM2322, PM2042, PM3122, PM3222, PM3332, PM2024, PM2124, PM2044, PM2144, PM3224, PM3334
DTC 3180/3280
DTC 329x (EISA) (Adaptec 154x compatible)
Future Domain TMC-16x0, TMC-3260 (PCI)
Future Domain TMC-8xx, TMC-950
Future Domain chips TMC-1800, TMC-18C50, TMC-18C30, TMC-36C70
ICP-Vortex PCI-SCSI Disk Array Controllers (many RAID levels supported) Patches for Linux 1.2.13 and 2.0.29 are available here. The controllers GDT6111RP, GDT6121RP, GDT6117RP, GDT6127RP, GDT6511RP, GDT6521RP, GDT6517RP, GDT6527RP, GDT6537RP and GDT6557RP are supported. You can also use pre-patch-2.0.31-4 to pre-patch-2.0.31-9.
ICP-Vortex EISA-SCSI Controllers (many RAID levels supported) Patches for Linux 1.2.13 and 2.0.29 are available here. The controllers GDT3000B, GDT3000A, GDT3010A, GDT3020A and GDT3050A are supported. You can also use pre-patch-2.0.31-4 to pre-patch-2.0.31-9.
Iomega PPA3 parallel port SCSI Host Bus Adapter embedded in ZIP drive
Initio Corp. INI-9090U INI-9100, INI-9100W/A/UW, INI-9200U/UW, INI-9400U/UW, INI-9520U/UW, INI-A100U2W
Initio Corp. INIC-950
Media Vision Pro Audio Spectrum 16 SCSI (ISA)
Mylex (formerly BusLogic) W Series (PCI) (BT-948, BT-958, BT-958D)
Mylex (formerly BusLogic) C Series (ISA/EISA/VLB/PCI) (BT-946C, BT-956C, BT-956CD, BT-445, BT-747C, BT-757C, BT-757CD, BT-545C, BT-540CF)
Mylex (formerly Buslogic) S Series (ISA/EISA/VLB) (BT-445S, BT-747S, BT-747D, BT-757S, BT-757D, BT-545S, BT-542D, BT-742A, BT-542B)
Mylex (formerly BusLogic) A Series (ISA/EISA) (BT-742A, BT-542B)
NCR 5380 generic cards
NCR 53C400 (Trantor T130B) (use generic NCR 5380 SCSI support)
NCR 53C406a (Acculogic ISApport / Media Vision Premium 3D SCSI)
NCR chips 53C7x0 (the 53C710 is only supported in PCI variant)
NCR chips 53C810(A), 53C815, 53C820, 53C825(A), 53C860, 53C875, 53C895 (53C895 supported 'on paper')
Qlogic / Control Concepts SCSI/IDE (FAS408) (ISA/VLB)
Qlogic FASXXX/FASXX family of chips (ISA/VLB)
QLogic IQ-PCI, IQ-PCI-10, IQ-PCI-D (PCI) (ISP1020 chip)
Quantum ISA-200S, ISA-250MG
Seagate ST-01/ST-02 (ISA)
SIIG Ultrawide SCSI Pro (Initio chipset).
SoundBlaster 16 SCSI-2 (Adaptec 152x compatible) (ISA)
Tekram DC-390, DC-390W/U/F
Trantor T128/T128F/T228 (ISA)
UltraStor 14F (ISA), 24F (EISA), 34F (VLB)
Western Digital WD7000 SCSI
Initio Scsi & Raid Devices Driver Download Windows 10
AMD AM79C974 (PCI) (Compaq, HP, Zeos onboard SCSI)
(driver)
Adaptec ACB-40xx SCSI-MFM/RLL bridgeboard
(driver)
Always Technologies AL-500
(driver)
Iomega PC2/2B
(driver)
Ricoh GSI-8
(driver)
8.3. UnsupportedAdaptec AHA 2940UW Pro
Adaptec AAA-13x RAID Adapters
Adaptec AAA-113x Raid Port Cards
Adaptec AIC-7810
NCR chip 53C710 (ISA) (old obsolete chip, but still used in some Compaq models)
Non Adaptec compatible DTC boards (327x, 328x)
Category: System and controllers
Manufacturer: Initio
Caution Level: intermediate
Operating System: Windows DOS, 3.1, 3.2, 95, NT, Netware, SCO UNIX and UNIXware
Windows device driver information for Initio INI-9100/9100W SCSI Host Adapter
The Initio INI-9100/9100W SCSI Host Adapter is an adapter that conforms to high performance demands and compatibility in computer storage subsystems. It is a small system interface for computers, which conforms to both IDE/E and IDE standards of data transfer. The adapter has a programmed I/O, which prevents the host computer from performing other tasks when data is being transferred. As such, data transfer is faster. In the past, the inclusion of SCSI meant that, 90 percent of the CPU would be used in data transfer instead of basic computing. With IDE/E and IDE standards however, the device has achieved better multi-tasking capabilities. The SCSI's multi threading scheme in the device also means that CPU waiting time is considerably lower. The device also registers increased storage capacity in the subsystem. In addition, the Initio INI-9100/9100W SCSI Host Adapter conforms to the SCSI standard, which is the contemporary standard used by most adapter manufacturers.
Outdated Drivers?
Unless you update your drivers regularly you may face hardware performance issues.
To check your drivers you should manually verify every device on your system for driver updates
The Initio INI-9100/9100W SCSI Host Adapter can connect up to seven peripherals on the slim SCSI, while as the wider SCSI can hold up to 15 peripherals. This is unlike E-IDE, which can only hold four drives at a time. The INI-900/9100W has a technological advantage over other SCSI adapter since products withing the 9100 family use ISGE# engine. This is an engine built to accommodate lower overhead loading for all SCSI devices by Initio. The benefits of using such is that the user can access higher and efficient data transfer rates. Adapters in the 9100 family also has a compatibility advantage, which results form the manufacturers efforts at testing and certifying that the adapters can work well with major hardware and software. Supported operating systems include windows DOS, 3.1, 3.2, 95, NT, Netware, SCO UNIX and UNIXware. Updating the device drivers is necessary in order to ensure that the device functions properly. It is highly recommended you run a free registry scan for Windows and Initio INI-9100/9100W SCSI Host Adapter errors before installing any driver updates.
Comments are closed.